The installation of the ink scraper, ink scraper Angle setting, the size of the ink scraper pressure.Through the adjustment of the scraper, not only can solve the ink scraper itself caused by knife wire and can overcome some common problems in printing.With the continuous improvement of printing process and requirements, in some special ink printing and special printing substrates, often appear some insurmountable problems, such as irregular stealth knife wire, etc.In addition, ink scraper pressure is too big, can reduce the ink of lubrication.
To increase the printing pressure, not only limited to directly increase the pressure to achieve a goal, it will direct damage on version of roller and ink scraper.By adjusting the installation method of scraper is also effective.According to the different printing equipment, can through the following ways to adjust the ink scraper: hard and soft lining knife thickness: when the line edge tool slide (Y) = 7 ~ 10 mm, the thickness of the lining knife blade is 2 times, that is: 0.30 ~ 0.35 mm.When lining edge tool post of (Y) = 10 ~ 25 mm, the thickness of the lining knife is 3 times of the blade, namely: about 0.50 mm.Scraper and the distance line knife (X) : hard outfit knife: X = 3 mm, can effectively solve the ink scrape isn't clean.Neutral with knife: X = 4 mm, standard knife.Soft outfit knife: X = 5 mm, is advantageous to the network transfer and coarser particles ink printing